Quincy Air Treatment
Refrigerated Dryers

Quincy Refrigerated Air Dryers purify compressed air by chilling it to approximately 37°F. This causes entrained moisture to condense. Condensed moisture carries airborne dirt and oil to the separator where it is removed from the air stream by an automatic drain

 
  • Cycling
  • Non-cycling
  • High Temperature
 
 
  QPNC Non-Cycling Dryer

Best suited for smaller systems expecting fairly constant loads.Thess units use a two-stage heat exchanger to maintain consistent dew points. Freeze-ups are prevented and optimum performance is maintained.

 
 
  • 39°F dewpoint
  • 10 - 4,000 cfm
  • 150 psig max
 
 



 
  QED and QPCD Cycling Dryer

Most Efficient Drying Technology Available.

These units save energy by cycling the refrigeration on and off in response to demand. A three-stage heat exchanger system is employed to provide the cold storage necessary for the operation

 
 
  • 35°F dewpoint
  • 10 - 4,000 cfm
  • 150 psig max
 
 



 
  QRHT Compact High Temperature Dryer

Accepts 180°F Inlet Temperature

Designed for reciprocating compressors with high discharge temperatures, these dryers eliminate water, oil and dirt from air systems, preventing damage to pneumatic tools and cylinders. The result is fewer product defects and no "fisheye" paint splotches.

 
 
  • 39°F dewpoint
  • 25 - 125 cfm
  • 175 psig max
  • Space-saving 3-in-1 design
 
 




 

  Desiccant Dryers

Quincy desiccant dryers provide air purification from -40°F PDP down to -100°F PDP. These dryers are built and designed to provide the smallest footprint possible while ensuring maximum performance. Quincy desiccant dryers have ASME and CRN designed pressure vessels standard. Also, standard with the desiccant dryers is a 2-year package warranty and a 5-year valve warranty

  • Heatless
  • Heated Purge
  • Blower Purge
 
 
  QHD Heatless Desiccant Dryer

These dryers use a small portion of the dried compressed air to regenerate the off-line tower

Low initial and maintenance cost, moderate to high operating cost.

 
 
  • 40° to -100°F dewpoint
  • 100 - 3,400 cfm
  • 14% purge
  • Microprocessor control
 
 



 
  QMOD Heatless Modular Desiccant Dryer

These compact dryers use a small portion of dried compressed air to regenerate the offline tower

Low initial and maintenance cost, moderate to high operating cost.

 
 
  • -40°F to -100°F dewpoint
  • 8 - 365 cfm
  • 18% purge
  • CRN Approved
 
 



 
  QDHP Heated Purge Desiccant Dryer

These dryers use half the compressed air to regenerate the off line tower than the heatless series

Low maintenance cost, moderate initial cost and moderately low operating cost.

The optional Quincy MicroBurst Regeneration (MBR) system is the only full load energy saver available for use with heated purge desiccant air dryers. The MBR cuts purge requirements in half and greatly reduces heater "on" time. When equipped with the Quincy MBR, our Heated Purge dryers use 50% less energy. ROI can be realized within 5 months, depending on dryer size and local power costs.

 
   
 



 
  QDBP Blower Purge Desiccant Dryer

These dryers combine heat with forced ambient air for regeneration

Moderately low maintenance cost, high initial cost and moderately low operating cost

 
 
  • +10° to -40°F dewpoint
  • 300 - 3,400 cfm
  • 2% Average Purge
  • NEMA 4
 
 




 

Filtration

 
  Standard Filters
  • Particulate
  • Coalescer
  • Absorber
 
 



 
  High Pressure Filters
  • Aluminum alloy
  • 316 stainless steel
  • 750, 1500 & 5000 psig
  • 28 to 3000 cfm
 
 



 
  Mist Eliminators
  • Double element design
  • Pressure drop < 1 psig
  • 10-year element life
  • Large tank volume
  • Optional no-loss drain
 
 



 
  Preferred Elements
  • Direct fit
  • Logical part numbers
  • Cross reference guide
  • Fast delivery
 
 





< back to previous